Felt oil-seal requirements should be reviewed as part of a defined assembly. Dimensions, shaft contact, lubricant, temperature, and movement determine what needs to be tested.
Request a custom quote · Quotation checklist
Where this product fits
Send the drawing or removed sample with the installation context; a generic ring photo is not enough to establish sealing suitability.
- felt elements for specified oil-contact assemblies
- ring or shaped components in equipment programs
- replacement-part development from a drawing or approved sample
What to send for a custom quotation
- custom inside and outside dimensions, thickness, profile, and tolerance
- shaft and housing surfaces, fit, movement, and operating speed
- lubricant or contact medium, temperature, moisture, and pressure conditions
- required leakage or retention criteria, quantity, and validation plan
Dimensions are made to your approved drawing or sample. Material, tolerances, quantity, packaging, and timing are confirmed during the project review.
Material, sample and production review
We review material and geometry with the application’s sealing requirement. Compatibility, wear, fit, and leakage performance must be validated in the buyer’s assembly before the part is approved for use.
Use the gasket and seal inquiry comparison to describe the intended function alongside the part name, then identify the approval checks required for the actual assembly.
Selection notes
A felt component may serve wiping, retention, or protection roles in different designs. If the project requires a specified seal performance, state the acceptance criteria explicitly.
Frequently asked question
Can you quote a felt oil seal from a drawing?
Yes. Include the assembly conditions and contact medium along with the dimensions, so the material and sample checks can be scoped.
Related felt solutions
Request a quote
Send your drawing, sample photos, target dimensions, application, quantity, and destination through our B2B project inquiry form. Attach one PDF, JPG, JPEG, PNG, DXF, or DWG file up to 10 MB. We will review the brief and confirm the open specification points.