Adhesive felt strips are supplied by a defined width, thickness, length, backing, and installation surface for OEM and project use.
Request a custom quote · Quotation checklist

Where this product fits
Specify whether you need a roll, cut lengths, or individually packed pieces; that choice affects handling and the way the adhesive is protected.
- edge and contact-surface protection
- assembly strips for cushioning or separation
- cut-length strips for installation or product kits
What to send for a custom quotation
- strip width, felt thickness, roll length or cut-piece length
- felt material, color, edge quality, and backing width
- substrate, surface texture, cleaning method, temperature, and moisture
- release liner format, quantity, packing, and application method
Dimensions are made to your approved drawing or sample. Material, tolerances, quantity, packaging, and timing are confirmed during the project review.
Specify felt width, adhesive coverage and liner dimensions
Identify these dimensions separately in the brief. State the felt strip width, the intended adhesive coverage or offset, and any release-liner extension needed for handling. A single “strip width” value leaves those construction details open; proposed arrangements must be confirmed for the project.
For thickness, state whether the requirement applies to the felt layer, the backed construction excluding the liner, or the supplied stack including the liner. Record the measurement method and permitted limits so the sample and production requirement refer to the same construction.
What should a cut-length adhesive strip sample check?
Check the identified dimensions and edge, then review liner removal, placement and adhesion on the actual surface using the agreed preparation and installation procedure. Record which face was applied and any movement or corner condition assessed. Use the sample approval checklist to distinguish a dimensional approval from an application approval.
Material, sample and production review
We review felt and adhesive as one construction. Sample checks should cover strip width, liner handling, application on the actual substrate, and how the strip behaves around corners or under movement.
For backing, surface, liner and sample approval details, use the adhesive-backed felt specification checklist when preparing the inquiry.
Selection notes
For broad sheet areas or shaped pads, adhesive-backed felt can be more suitable than a narrow strip. Continuous rolls and cut pieces are quoted from the same project-specific specification.
Before approving a backing, agree the installation surface and acceptance criteria. Use the adhesive-backed sample checklist for substrate, installation, use-condition, and removal checks.
Frequently asked question
Can the strip width and length be customized?
Yes. Send the required width, length format, surface, and use conditions; final dimensions are confirmed against the brief.
Related felt solutions
Request a quote
Send your drawing, sample photos, target dimensions, application, quantity, and destination through our B2B project inquiry form. Attach one PDF, JPG, JPEG, PNG, DXF, or DWG file up to 10 MB. For larger or multiple files, describe what is available in the project details. We will review the brief and confirm the open specification points.